Rapid Spray Spot Ranger Operators Handbook
Rapid Spray Equipment by Rapid Spray
4
ASSEMBLY
The following steps are given as a guide to assemble your
spot sprayer:
1. Check inside tank for any foreign objects.
2. Remove hose wraps, screws clamps, bungee cords
and gauge from parts bag.
3. Install hose wraps and bungee cords using screws
provided, taking care not to over tighten the screws.
4. Attach hose to the discharge port of the regulator
using worm drive clamp provided.
5. Install drain bung.
6. Fit lid on top of tank.
OPERATION
The following steps are given as a guide to operate your Spot Ranger sprayer.
•
When mounting sprayer to vehicle using a ratchet tie-down strap, check that the spray
tank is still secure after the first 15 minutes of operation and re-tighten if necessary.
•
Partially fill the tank with clean water.
•
Connect the battery clips to a 12V DC power supply (red to positive terminal, black to
negative terminal) ensuring sufficient current capability (amps) to suit the pump. The
pump’s maximum amperage requirement is shown on its name plate.
•
In order to prime the system and enable the pump to reach full pressure, depress the
hand lance trigger to release trapped air. The pump may automatically switch off when
the hand lance trigger is released.
•
Pump cycling may occur with insufficient nozzle delivery. This continual switching on
and off will reduce battery and motor life. Should this occur, adjust the setting of the
nozzle tip or the regulator until the cycling stops.
