4000-S
ERIES
I
NSTALLATION
, O
PERATION
AND
S
ERVICE
M
ANUAL
6 of 154
SECTION 2: INSTALLER RESPONSIBILITY
The installer is responsible for the follo
w
ing:
• To install and commission the air handler, as
w
ell
as the gas and electrical s
u
pplies, in accordance
w
ith applicable specifications and codes. Rapid
Engineering LLC recommends the installer
contact a local b
u
ilding inspector or Fire Marshal
for g
u
idance.
• To
u
se the information gi
v
en in a layo
u
t dra
w
ing
and in the man
u
al together
w
ith the cited codes
and reg
u
lations to perform the installation.
• To install the air handler in accordance
w
ith
clearances to comb
u
stibles.
• To f
u
rnish all needed materials not f
u
rnished as
standard eq
u
ipment.
• To plan location of s
u
pports.
• To pro
v
ide access to air handler for ser
v
icing.
• To pro
v
ide the o
w
ner
w
ith a copy of this
Installation, Operation and Ser
v
ice Man
u
al.
• To ne
v
er
u
se air handler as s
u
pport for a ladder or
other access eq
u
ipment and ne
v
er hang or
s
u
spend anything from heater.
• To ens
u
re there is adeq
u
ate air circ
u
lation aro
u
nd
the air handler and to s
u
pply air for comb
u
stion,
v
entilation and distrib
u
tion in accordance
w
ith
local codes.
• To assemble or install any accessories or
associated d
u
ct
w
ork
u
sing best b
u
ilding
practices.
• To properly size s
u
pports and hanging materials.
• To ens
u
re air handler is placed in an appro
v
ed
application.
• To pro
v
ide b
u
ilding press
u
re relief/dampers fans
to pre
v
ent o
v
er press
u
rization of a b
u
ilding, if
needed.
2.1 Corrosive Chemicals
Rapid Engineering LLC cannot be responsible for
ens
u
ring that all appropriate safety meas
u
res are
u
ndertaken prior to installation; this is entirely the
responsibility of the installer. It is essential that the
contractor, the s
u
b-contractor, or the o
w
ner identifies
the presence of comb
u
stible materials, corrosi
v
e
chemicals or halogenated hydrocarbons* any
w
here
in the premises.
* Halogenated Hydrocarbons
are a family of chemical
compounds characterized by the presence of halogen elements
(fluorine, chlorine, bromine, etc.). These compounds are
frequently used in refrigerants, cleaning agents, solvents, etc. If
these compounds enter the air supply of the burner, the life span
of the air handler components will be greatly reduced. The loca-
tion of the outside air supply must be carefully chosen to supply
outside air, free of these compounds, to the burners whenever
the presence of these compounds is suspect. Warranty will be
invalid if the air handler is exposed to halogenated hydrocar-
bons.
2.2 National Standards and Applicable Codes
All appliances m
u
st be installed in accordance
w
ith
the latest re
v
ision of the applicable standards and
national codes. This refers also to the electric, gas
and
v
enting installation. Note: Additional standards
for installations in p
u
blic garages, aircraft hangars,
etc. may be applicable.
2.3 Re
q
uired E
q
uipment
When lifting of the eq
u
ipment is req
u
ired, the
installing contractor is responsible for s
u
pplying or
arranging for the appropriate lifting eq
u
ipment so that
WARNING
Explosion Hazard
Equipment must have access to
uncontaminated air at all times.
Failure to follow these instructions can result
in death, injury or property damage.
CAUTION
Product Damage Hazard
Do not use equipment in area containing
corrosive chemicals.
Refer to appropriate Material Safety Data
Sheets (MSDS).
Failure to follow these instructions can result
in product damage.
Summary of Contents for 4044
