7
e)
Maintain power tools. Check
for misalignment or binding
of moving parts, breakage of
parts and any other condi-
tion that may affect the power
tool’s operation. If damaged,
have the power tool repaired
before use.
Many accidents are
caused by poorly maintained
power tools.
f)
Keep cutting tools sharp and
clean.
Properly maintained
cutting tools with sharp cutting
edges are less likely to bind and
are easier to control.
g)
Use the power tool, accesso-
ries and tool bits etc. in accor-
dance with these instructions,
taking into account the wor-
king conditions and the work
to be performed.
Use of the
power tool for operations dif-
ferent from those intended could
result in a hazardous situation.
h)
Keep handles and grasping
surfaces dry, clean and free
from oil and grease.
Slippery
handles and grasping surfaces
do not allow for safe handling
and control of the tool in
unexpected situations.
5) SERVICE
a)
Have your power tool serviced
by a qualifi ed repair person
using only identical replace-
ment parts.
This will ensure that
the safety of the power tool is
maintained.
TACKER SAFETY WARNINGS
Always assume that the tool
contains fasteners.
Careless
handling of the tacker can result in
unexpected firing of fasteners and
personal injury.
Do not point the tool towards
yourself or anyone nearby.
Unexpected triggering will
discharge the fastener causing an
injury.
Do not actuate the tool unless
the tool is placed firmly against
the work piece.
If the tool is not
in contact with the work piece, the
fastener may be deflected away
from your target.
Disconnect the tool from the
power source when the fastener
jams in the tool.
While removing
a jammed fastener, the tacker may
be accidentally activated if it is
plugged in.
Use caution while removing a
jammed fastener.
The mechanism
may be under compression and
the fastener may be forcefully
discharged while attempting to free
a jammed condition.
Do not use this tacker for
fastening electrical cables.
It is
not designed for electric cable
installation and may damage the
insulation of electric cables thereby
causing electric shock or fire
hazards.
The machine shall be used in a
covered and dry area. The ambient
temperature shall be included
between 15°C and 30°C. The
humidity level shall be less than
60%.
TECHNICAL SPECIFICATION
Model Number
ESN530
ESN114
Staple type
Rapid 53
Rapid 140
Staple length
6-14 mm
6-14 mm
Summary of Contents for ESN114
