Inside
Hood
Wiring
for
LED
Strings
to
V+
and
V
‐
Each
driver
has
a
V+
and
V
‐
output
that
powers
the
LED
strings.
Since
we
cannot
put
the
drivers
in
the
hood
next
to
the
LEDs,
we
will
attach
some
wire
to
the
driver
jumpers
and
run
that
through
the
empty
space
left
from
removing
some
of
the
power
cords.
We
start
by
running
our
wire
through
the
void
left
by
one
of
the
cut
power
cords.
Next,
we
run
it
through
the
rubber
grommet
separating
the
interior
of
the
protected
hood
from
the
exterior.
Tie
a
loose
knot
around
the
strain
relief
post
to
prevent
damage
to
internal
components
if
the
outer
wires
get
pulled
too
hard.
