RapidSignage - Rapid Digital Signage Deployments
With DHCP networking:
If you want the RS-10 connect to a DHCP network, you need to directly connect with RS-10 first and
change the networking setting of the RS-10:
1.
Click
SystemConfig
on the main page of RS-10, then click
Network config
Tab.
2.
Double-click textbox of DHCP and make sure DHCP is turned on, then Click
Apply
.
3.
Click
Power
tab, and click
Reboot
button to reboot the RS-10.
4.
After reboot, the RS-10 IP address will be displayed on the boot screen.
Example:
Change the RS-10 into the diagram below:
AP / Router / Switch
