1. Push the release lever until it is caught
by the release stopper.
Release lever
Release stopper
2. Remove the wire coil.
3. Push the reel stopper to release the
reel stay and open it at the same time,
remove the wire coil.
4. Load new wire coil (refer to previous
instructions for loading wire coil).
5. Perform a test tie, to check if the tie
tension of set correctly.
Wire
Pipe
Reel stay
Reel stopper
6. Make sure that the wire is tight and firm.
Prevent the wire from curling up behind
the wire coil. This may cause a jam.
7. Insert battery into machine battery slot
and set the main switch to ON. Release
the trigger lock before starting to tie.
Replacing Wire Coil
Warning - Ensure trigger lock is on, power is
switched off and battery removed.