Raptor LW75, Operating & Maintenance Instructions

- 3 - 

3 - IN SERVICE INSPECTION & MAINTENANCE 

INITIAL INSPECTION 

Check that the correct hoist and the capacity of hoist are suitable for the job in hand. 

Prior to operating hoist for the first time, the hoist must be checked by a competent 

person. Visually check hoist has been delivered and/or stored in a safe and undamaged 

condition. 

IN-SERVICE INSPECTION – Before operation 

Prior to operating hoist check all components are free from excessive wear and general 

condition of hoist is good. Inspect the housing, chain and hooks are all in good working 

condition. If hoist is fitted with brake it should be tested before operation. Check that 

anchor point is sufficient to take the intended load. 

LOAD CHAIN INSPECTION 

The Load Chain should be inspected for wear, defects, and deformations or 

superficial/corrosion marks before use, if operator is unsure of condition of chain it 

should be checked by a trained and competent person. Clean and lubricate at regular 

intervals. 

CHAIN STOP INSPECTION 

Check that the chain stop is fitted securely to one link of chain only. 

TOP/BOTTOM HOOK INSPECTION 

Both the top and bottom hooks should be inspected for wear, defects, and deformations 

or superficial/corrosion marks before use. Check that safety catches are fitted and are 

working correctly if operator is unsure of condition of hooks, they should be checked by 

a trained and competent person.