36 C
OMMAND
C
ENTER
S
ECURE
G
ATEWAY
A
DMINISTRATOR
G
UIDE
Add a Device
Devices must be added to CC-SG before you can configure ports or add Out-of-Band interfaces
to Nodes through those ports.
Add Device
is used to add devices whose properties you know and
can provide to CC-SG.
To add a device to CC-SG:
10.
On the
Devices
menu, click
Device Manager
, and then click
Add Device
. The
Add Device
screen appears.
Figure 30 Add Device Screen
11.
Click the
Device Type
drop-down arrow and then select the type of device you are adding
from the list. If you select
PowerStrip
, you will see a slightly different Add Device screen.
Adding a KVM or Serial Device
12.
Type a name for the device in the
Device name
field.
13.
Type the IP Address or Hostname of the device in the
Device IP or Hostname
field. For
hostname rules, refer to
Terminology/Acronyms
in
Chapter 1: Introduction
.
14.
Type the TCP communication port used to communicate with the device in the
TCP port
number
field. The default port number for most Raritan devices is 5000.
15.
Type the name used to log onto this device in the
Username
field. If you followed the
Raritan Digital Solutions Deployment Guide
to prepare your devices to add to CC-SG,
type the username for the CC-SG Administrative User you configured on the device.
16.
Type the password needed to access this device in the
Password
field. If you followed the
Raritan Digital Solutions Deployment Guide
to prepare your devices to add to CC-SG,
type the password for the CC-SG Administrative User you configured on the device.
17.
Type the time (in seconds) that should elapse before timeout between the new device and CC-
SG in the
Heartbeat timeout (sec)
field.
18.
If applicable, check
Allowed
under
Local Access
if you want to allow users to have direct
access to this device while it is managed by CC-SG.
19.
Optionally, type a short description of this device in the
Description
field.
20.
Check
Configure all ports
if you want to automatically add all ports on this device to the
Devices tab, and create a Node for each port on this device in the Nodes tab. Corresponding
nodes and ports will be configured with matching names. If checked when the device is
added, a new node will be created for each port, and an out-of-band interface will be created
for that node.
Summary of Contents for CC-SG
