Chapter 9: Device Management
125
•
Discovery Port. Dominion KX II discovery occurs over a single,
configurable TCP Port. The default is Port 5000, but you can
configure it to use any TCP port except 80 and 443. To access the
Dominion KX II unit from beyond a firewall, your firewall settings
must enable two-way communication through the default port 5000
or a non-default port configured here. For more information, refer to
Configure Network Firewall Settings
(see "Change the Keyboard
Layout Code (Sun Targets)" on page 28).
•
Bandwidth Limit. The default is no limit. Select from among the
options in the drop-down list to set a maximum amount of
bandwidth that can be consumed by this Dominion KX II unit (for all
sessions). The options include: No Limit, 100 Megabit, 10 Megabit, 5
Megabit, 2 Megabit, 512 Kilobit, 256 Kilobit, and 128 Kilobit.
Note: Lower bandwidth may result in slower performance.
LAN Interface Settings
Figure 54: Network Settings (LAN Interface Settings)
•
The current parameter settings are identified in the Current LAN
interface parameters field.
•
LAN Interface Speed & Duplex. Select from among the speed and
duplex combinations available.
Autodetect Default
option
10 Mbps/Half
10 Mbps/Full
100 Mbps/Half
Summary of Contents for DOMINION KX II DKX2-0E-E
