Chapter 5: Using the Web Interface
100
To create firewall rules:
1. Choose Device Settings > Security. The Security Settings page
opens. Locate the panel labeled IP Access Control.
2. Ensure the Enable IP Access Control checkbox is selected.
3. Create specific rules. See the table for different operations.
Action
Do this...
Add a rule to the end of
the rules list
Type an IP address and subnet mask in the IP/Mask field.
Select ACCEPT or DROP from the drop-down list in the Policy
field.
Click
Append.
Do NOT enter a rule number. The system automatically numbers the
rule.
Insert a rule between two
existing rules
Type a rule number where you want to insert a new rule above in
the Rule # field. For example, to insert a rule between rules #3
and #4, type 4.
Type an IP address and subnet mask in the IP/Mask field.
Select ACCEPT or DROP from the drop-down list in the Policy
field.
Click
Insert.
The system inserts the rule and automatically renumbers the following
rules.
Replace an existing rule
Type the number of the rule to be replaced in the Rule # field.
Type an IP address and subnet mask in the IP/Mask field.
Select ACCEPT or DROP from the drop-down list in the Policy
field.
Click
Replace.
This system replaces the existing rule with the one you just created.