Chapter 7: Using the CLP Interface
175
5. Type a name and press Enter. The login name is case-sensitive, so
make sure you capitalize the correct letters. Then you are prompted to
enter a password.
6. Type a password and press Enter. The password is case sensitive, so
make sure you capitalize the correct letters. After properly entering the
password, the
clp:/->
system prompt appears.
7. You are now logged in to the command line interface and can begin
administering the Dominion PX device.
With SSH or Telnet
You can remotely log in to the command line interface using an SSH or
Telnet client, such as PuTTY.
Note: PuTTY is a free program you can download from the Internet. See
PuTTY's documentation for details on configuration.
To log in using SSH or Telnet:
1. Ensure SSH or Telnet has been enabled. See
Modifying the
Network Service Settings
(on page 58).
2. Launch an SSH or Telnet client and open a console window. A login
prompt appears.
3. Type a name and press Enter. The login name is case-sensitive, so
make sure you capitalize the correct letters.
Note: If using the SSH client, the name must NOT exceed 25
characters. Otherwise, the login fails.