Appendix D: Integration
217
Removing Power Associations
When disconnecting target servers and/or rack PDUs from the device, all
power associations should first be deleted. When a target has been
associated with a rack PDU and the target is removed from the device, the
power association remains. When this occurs, you are not able to access
the Port Configuration for that disconnected target server in Device
Settings so that the power association can be properly remove.
To remove a rack PDU association:
1. Select the appropriate rack PDU from the Power Strip Name
drop-down list.
2. For that rack PDU, select the appropriate outlet from the Outlet Name
drop-down list.
3. From the Outlet Name drop-down list, select None.
4. Click OK. That rack PDU/outlet association is removed and a
confirmation message is displayed.
To remove a rack PDU association if the rack PDU has been
removed from the target:
1. Click Device Settings > Port Configuration and then click on the active
target.
2. Associate the active target to the disconnected power port. This will
break the disconnected target's power association.
Finally, associate the active target to the correct power port.
Dominion KX I Power Strip Configuration
The Dominion KX (with the latest firmware) supports up to eight KX I
devices, and requires P2CIM-PWR and straight CAT5 cable. You can
associate up to four outlets to a target server. All four outlets can be from
separate Dominion PX devices, if needed.
Setup Preparation
You must have a power strip and the P2CIM-PWR Computer Interface
Module (CIM). By default the P2CIM-PWR is
not
included with Raritan
power strips.
To receive the P2CIM-PWR CIM with the power strip, you must order the
power strip with a part number that ends in PK (for example,
PCR8-15-PK). Alternatively, the CIM can be ordered separately from the
power strip. Raritan devices must be ordered from Raritan or an
authorized Raritan reseller.