Appendix E: Using the IPMI Tool Set
238
Get Power On Delay Command
Request Data
-
-
Response Data
1
Completion Code
2
delay in 1/10 seconds
Set Receptacle State Command
This command is used to switch on/off and recycle individual receptacles.
Request Data
1
# of receptacle
[7 - 5] reserved
[4 - 0] # of receptacle, 0 based, highest valid # depends on device model
2 new
state
[7 - 2] reserved
[1] 1b = recycle, ignoring [0], 0b = get new state from [0]
[0] 1b = power on, 0b = power off
Response Data
1
Completion Code
Get Receptacle State Command
Request Data
1
# of receptacle
[7 - 5] reserved
[4 - 0] # of receptacle, 0 based, highest valid # depends on device model
Response Data
1
Completion Code
2
current receptacle state and visual state
[7] reserved
[6] 1b = blinking, 0b = steady
[5] 1b = LED green on, 0b = off
[4] 1b = LED red on, 0b = off
[3] 1b = enqueued to be switched on, 0b = not enqueued
[2] 1b = in power cycle delay phase, 0b = not delayed
[1] 1b = released because of soft breaker, 0b = norm
[0] 1b = power on, 0b = power off
