Chapter 4: Using the PDU
33
Port
Used for...
the serial (COM) port on the computer.
The serial port is also used to interface with some Raritan access products
(such as the Dominion KX) through the use of a power CIM.
Feature
Connection to Raritan's environmental sensors.
LAN
Connecting the Dominion PX device to your company's network:
Connect a standard Cat5e/6 UTP cable to this port and connect the other end
to your network. This connection is necessary to administer or access the
Dominion PX device remotely using the web interface.
There are two small LEDs adjacent to the port:
Green indicates a physical link and activity.
Yellow indicates communications at 10/100 BaseT speeds.
Note: Connecting any power CIM except for the D2CIM-PWR (such as
P2CIM-PWR) to the Dominion PX serial port causes all outlets to switch
ON state, even if they were previously OFF.
LED Display
The LED display is located on the side where outlets are available.
The following picture shows the LED display.
The LED display consists of:
A row displaying three digits
A row displaying two digits
Up and Down buttons
