Appendix A: Specifications
245
Note: The target must be powered on in order for the SX II Port channel
LED to turn on and the SX II to detect the target.
•
When you physically disconnect a target from a port on an SX II, the
port channel's LED turns off.
•
When you log in to SX II and connect to a target via either Raritan
Serial Console (RSC), SSH or the Local Console, the port channel's
LED blinks.
The LED blinks until you end the your connection to the target.
If you are connected to more than one target at the same time, all
LEDs blink in unison.
•
When you press the SX II's Reset button to reset the appliance or
when you perform a reboot from the SX II GUI, the Power LED(s)
blinks as the appliance powers down and turns off.
While the appliance powers back up, the Power LED(s) continue to
blink.
Once the appliance is powered on, the Power LED(s) stop blinking
and the LED remains on.
Target Cable Connection Distances and Rates
SX II supports the following connection distances using a CAT5 cable
between its Serial port and a target.
Distance
Bits per second
300ft/91m
1,200
300ft/91m
1,800
300ft/91m
2,400
200ft/60m
4,800
100ft/30m
9,600
50ft/15m
19,200
25ft/7.5m
28,800
25ft/7.5m
38,400
16ft/5m
57,600
8ft/2.5m
115,200
4ft/1.2m
230,400
Summary of Contents for Dominion SX II
