Chapter 6: SX II Administration
82
4. Select the access permissions the group has to server ports and
power control. The default is Deny.
Select each port individually, or use the checkboxes at the bottom of
the page to apply permissions to all ports.
Deny - Denied access completely.
View - View but not interact with the connected target.
Control - Control the connected target.
Control must be assigned to the group if power control access
will also be granted.
5. Click OK to create the group and apply permissions.
For information on IP ACL, see
Create a Group with Limited Access to
SX II (IP Access Control List)
(on page 82).
Create a Group with Limited Access to SX II (IP Access Control List)
Important: Exercise caution when using group-based IP access control.
It is possible to be locked out of your SX II if your IP address is within a
range that has been denied access.
Summary of Contents for Dominion SX II
