OPERATION
3
A. Push Button Switch:
Press push-button switch and hold until all waste
is cleared from the toilet bowl.
B. ME Toilet Control:
1. Press and hold “Water Only” to add water
to the bowl
2. Press and hold “Empty” to evacuate the bowl
3. Press and hold “Flush” to bring water in
while bowl is evacuating
C. Multifunction Smart Switch:
1.
Empty Only:
Press Empty Only button to
evacuate the bowl. Discharge pump runs as
long as this button is held.
2.
Water Only
: Press Water Only switch to
add water in the bowl. Inlet water solenoid/
pump runs as long as button is pressed with
a seven seconds limit. After limit is reached
Water Only button is disabled to prevent
overflow of the bowl. To enable again, Empty
Only button must be pressed.
3.
Normal:
Press normal button once and
timed flushing cycle starts.
4.
Water saver:
Press the button and a water
saver cycle starts.
NOTE:
Holding tank full light will only illuminate if
the tank sensor has been added to the control.
