Chapter 5: Using the On-Screen Display Interface
41
Menu:
ID:
5.
Now move it to the position you prefer by pressing the arrow keys.
6.
To confirm the new position, press Esc. Then the OSD returns to the
SETUP page shown in step 2.
7.
To exit the SETUP page, press Esc.
Channel Scan
You can turn on the Scan function to have the MCD automatically display
the video of every channel one by one on the screen. If the system scans
a channel port where a 2nd-tier switch is connected, it will scan all
channels of the 2nd-tier switch first before proceeding with the next
channels on the base switch.
Before turning on the scan function, make sure the Scan Mode and Scan
Rate settings meet your needs. See
Available Settings and Options
(on
page 38).
To activate the channel scan:
1.
If the OSD is not displayed, press the hot key 3 times.
The default hot key is 'Scroll Lock.' To change it, see
System
Settings
(on page 38).
2.
On the Selection Menu, press F2 to activate the scan mode.
3.
The scan starts from the channel next to the currently-selected
channel.
