Chapter 5: Introduction to PDU Components
99
Number Description
Sensor names.
Sensor readings and/or states.
A numeric sensor shows both the reading and state. A state sensor or
actuator shows the state only.
Available states are listed below. For further information, see
Sensor/Actuator States
(on page 182).
Alarmed
Lower Critical = below lower critical
Lower Warning = below lower warning
Upper Warning = above upper warning
Upper Critical = above upper critical
Open (for overcurrent protectors)
3.
Press
/
or
/
to view additional pages. When there
are multiple pages, page numbers appear in the top-right corner of
the display.
PDU
Depending on the model you purchased, the "PDU" menu command may
show one or all of the following data.
Internal beeper states -- On or Off
Total active power of the PX3 -- available on multi-inlet models and
in-line monitors only
Total active energy of the PX3 -- available on multi-inlet models and
in-line monitors only
12V power supply status -- available on iX7
™
models only
Tip: The internal beeper state information is also available in the PX3
web interface. See
PDU
(on page 145).
To view or configure PDU information:
1.
Press
/
or
/
to select "PDU" in the Main Menu, and
press
/
.
2.
The internal beeper state is shown: Active or Off.
Summary of Contents for PX3-1000 series
