Chapter 2: Rackmount, Inlet and Outlet Connections
11
3.
Align the claw-foot brackets with the baseplates so that the five
screw-holes on the baseplates line up through the bracket's slots.
The rackmount side of brackets should face either the left or right
side of the PX3 device.
4.
Fasten the brackets in place with at least three screws (one through
each slot). Use additional screws as desired.
5.
Using rack screws, fasten the PX3 device to the rack through the
claw-foot brackets.
Summary of Contents for PX3-1000 series
