Chapter 8: Using the Command Line Interface
457
config:#
security strongPasswords enforceAtLeastOneSpecialCharacter <option>
Variables:
<option> is one of the options:
enable or disable.
Option
Description
enable
At least one special character is required.
disable
No special character is required.
Maximum Password History
This command determines the number of previous passwords that
CANNOT be repeated when changing the password.
config:#
security strongPasswords passwordHistoryDepth <value>
Variables:
<value> is an integer between 1 and 12.
Role-Based Access Control
In addition to firewall access control based on IP addresses, you can
configure other access control rules that are based on both IP addresses
and users' roles.
An IPv4 role-based access control command begins with
security
roleBasedAccessControl ipv4.
An IPv6 role-based access control command begins with
security
roleBasedAccessControl ipv6.
Modifying Role-Based Access Control Parameters
There are different commands for modifying role-based access control
parameters.
IPv4 commands
Enable or disable the IPv4 role-based access control feature:
config:#
security roleBasedAccessControl ipv4 enabled <option>
Determine the IPv4 role-based access control policy:
Summary of Contents for PX3-1000 series
