Chapter 8: Using the Command Line Interface
464
config:#
security ipAccessControl ipv4 rule add 192.168.84.123/24 accept
insertAbove 5
Results:
A new IPv4 firewall control rule is added to accept all packets sent
from the IPv4 address 192.168.84.123.
The newly-added rule is inserted above the 5th rule. That is, the new
rule becomes the 5th rule, and the original 5th rule becomes the 6th
rule.
Example 3 - User Blocking
The following command sets up two user blocking parameters.
config:#
security userBlocking maximumNumberOfFailedLogins 5 blockTime 30
Results:
The maximum number of failed logins is set to 5.
The user blocking time is set to 30 minutes.
Example 4 - Adding an IPv4 Role-based Access Control Rule
The following command creates a newIPv4 role-based access control
rule and specifies its location in the list.
config:#
security roleBasedAccessControl ipv4 rule add 192.168.78.50 192.168.90.100
admin deny insertAbove 3
Results:
A new IPv4 role-based access control rule is added, dropping all
packets from any IPv4 address between 192.168.78.50 and
192.168.90.100 when the user is a member of the role "admin."
The newly-added IPv4 rule is inserted above the 3rd rule. That is, the
new rule becomes the 3rd rule, and the original 3rd rule becomes
the 4th rule.
Summary of Contents for PX3-1000 series
