Chapter 3: Initial Installation and Configuration
29
PX3-iX7 models:
To use the command line interface (CLI) for configuration, establish an
RS-232 or USB connection.
To use a web browser for configuration, make a network connection to
the computer. The PX3 is automatically configured with the following
link-local addressing in any network without DHCP available:
https://169.254.x.x (where x is a number)
https://pdu.local
See
APIPA and Link-Local Addressing
(on page 3).
Establish one of the following connections to a computer.
Serial connection for "DB9" RS-232 connector on PX3:
1.
Connect one end of the null-modem DB9 cable to the male "DB9"
RS-232 port labeled CONSOLE / MODEM on the PX3.
2.
Connect the other end to your computer's RS-232 port (COM).
3.
Perform
Initial Network Configuration via CLI
(on page 32).
Serial connection for "RJ-45" RS-232 connector on PX3-iX7:
The iX7
™
PDU's serial connection procedure is the same as above
except that a third party RJ-45 to "DB9 female" adapter/cable is
required, such as the blue Cisco adapter cable. This is because the
CONSOLE / MODEM port on iX7
™
is a female RJ-45 connector.
See
RJ45-to-DB9 Cable Requirements for Computer Connections
(for iX7
™
Only)
(on page 30).
USB connection:
1.
A USB-to-serial driver is required in Windows
®
. Install this driver
before connecting the USB cable. See
Installing the USB-to-Serial
Driver (Optional)
(on page 31).
Summary of Contents for PX3-1000 series
