Chapter 5: Introduction to PDU Components
93
Automatic and Manual Modes
After powering on or resetting the PX3, the front panel LCD display first
shows the Raritan logo, and then enters the automatic mode.
Automatic mode without alerts available:
In this mode, the LCD display cycles through the inlet information as
long as there are no alerts.
If overcurrent protectors are available on your PX3, the display cycles
between both the inlet and overcurrent protector information.
Note: You can make a PX3 with overcurrent protectors show the inlet
information only in the automatic mode. See
Front Panel Settings
(on
page 324).
Manual mode:
To view more information or control outlets if your PX3 is
outlet-switching capable, enter the manual mode.
Press
/
or
/
to enter the manual mode, where the Main
Menu is first displayed. See
Main Menu
(on page 96).
To return to the automatic mode, press
/
once or multiple times.
When an alert exists:
In the automatic mode, when an alert occurs, the LCD display stops
cycling through the inlet information, and warns you by showing the
alerts notice in a yellow or red background. See
Alerts Notice in a
Yellow or Red Screen
(on page 116).
To enter the manual mode, press
/
.
In the manual mode, both the top and bottom bars will turn yellow or
red to indicate the presence of any alert. See
Operating the
Dot-Matrix LCD Display
(on page 95).
Summary of Contents for PX3-1000 series
