Chapter 5: Introduction to PDU Components
120
Fuse
Some PX3 devices may be implemented with fuses instead of circuit
breakers. A fuse blows to protect associated outlets if it detects the
overload.
If your PDU uses fuses, you must replace it with a new one when it blows
or malfunctions. The rating of the new fuse must be the same as the
original one.
Use of inappropriately rated fuse results
in damage to the PDU and connected
equipment, electric shock, fire, personal
injury or death.
Depending on the design of your PDU, the fuse replacement methods
differ.
Fuse Replacement on Zero U Models
This section only applies to a Zero U PDU with "replaceable" fuses.
To replace a fuse on Zero U models:
1.
Lift the hinged cover over the fuse.
2.
Verify the new fuse's rating against the rating specified in the fuse
holder's cover.
Summary of Contents for PX3-1000 series
