Chapter 6: Using the Web Interface
234
"Port Forwarding" mode:
In this mode, the DHCP server communicates with the master device
alone and assigns only one IP address. All slave devices share the
same IP address as the master device. You must specify a 5XXXX port
number (where X is a number) when remotely accessing any slave
device via the shared IP address. See
Port Number Syntax
(on page
Port Number Syntax
In the Port Forwarding mode, all devices in the USB-cascading
configuration share the same IP address. To access any cascaded device,
you must assign an appropriate port number to it.
Master device: The port number is either
5NNXX or the standard
TCP/UDP port.
Slave device: The port number is
5NNXX.
5NNXX port number syntax:
NN is a two-digit number representing the network protocol as
shown below:
Protocols
NN
HTTPS 00
HTTP 01
SSH 02
TELNET 03
SNMP 05
MODBUS 06
XX is a two-digit number representing the device position as shown
below.
The following table only lists 7 slave devices, but the port forwarding
supports up to 15 slave devices.
Summary of Contents for PX3-1000 series
