Chapter 6: Using the Web Interface
250
Creating Role Access Control Rules
Role-based access control rules are similar to IP access control rules,
except they are applied to members of a specific role. This enables you
to grant system permissions to a specific role, based on their IP
addresses.
Same as IP access control rules, the order of role-based access control
rules is important, since the rules are executed in numerical order.
To create IPv4 role-based access control rules:
1.
Choose Device Settings > Security > Role Access Control.
2.
Select the "Enable Role Based Access Control for IPv4" checkbox to
enable IPv4 access control rules.
3.
Determine the IPv4 default policy.
Allow: Accepts traffic from all IPv4 addresses regardless of the
user's role.
Deny: Drops traffic from all IPv4 addresses regardless of the
user's role.
4.
Create rules. See the tables for different operations.
ADD a rule to the end of the list
Click Append.
Type a starting IP address in the Start IP field.
Type an ending IP address in the End IP field.
Select a role in the Role field. This rule applies to members of this role only.
Select an option in the Policy field.
Allow: Accepts traffic from the specified IP address range when the user is a
member of the specified role
Deny: Drops traffic from the specified IP address range when the user is a
member of the specified role
Summary of Contents for PX3-1000 series
