6
In This Chapter
Circuit Breaker Orientation Limitation .......................................................6
Rack-Mounting the PDU..............................................................................6
Connecting a Locking Line Cord ............................................................... 16
Installing Cable Retention Clips on the Inlet (Optional) ........................... 18
Installing Cable Retention Clips on Outlets (Optional) ............................. 19
Locking Outlets and Cords ........................................................................ 20
Circuit Breaker Orientation Limitation
Usually a PDU can be mounted in any orientation. However, when
mounting a PDU with circuit breakers, you must obey these rules:
Circuit breakers CANNOT face down. For example, do not
horizontally mount a Zero U PDU with circuit breakers on the ceiling.
If a rack is subject to shock in environments such as boats or
airplanes, the PDU CANNOT be mounted upside down. If installed
upside down, shock stress reduces the trip point by 10%.
Note: If normally the line cord is down, upside down means the line
cord is up.
Rack-Mounting the PDU
This chapter describes how to rack mount a PX3 device. To mount a Zero
U PX-1000 series PDU, you can use either two buttons or L-brackets that
Raritan provided.
Rackmount Safety Guidelines
In Raritan products which require rack mounting, follow these
precautions:
Operation temperature in a closed rack environment may be
greater than room temperature. Do not exceed the rated
maximum ambient temperature of the Power Distribution Units.
See
Specifications
(on page 540) in the User Guide.
Ensure sufficient airflow through the rack environment.
Mount equipment in the rack carefully to avoid uneven
mechanical loading.
Chapter 2
Rackmount, Inlet and Outlet
Connections
Summary of Contents for PX3-1000 series
