Chapter 6: Using the Web Interface
260
If using a Microsoft Active Directory server, consult your AD
administrator for the name of the Active Directory Domain.
Bind Distinguished Name (DN) and password (if anonymous bind is
NOT used)
The Base DN of the server (used for searching for users)
The login name attribute (or AuthorizationString)
The user entry object class
The user search subfilter (or BaseSearch)
Information needed for Radius authentication:
The IP address or host name of the Radius server
Authentication protocol used by the Radius server
Shared secret for a secure communication
UDP authentication port and accounting port used by the Radius
server
Adding LDAP/LDAPS Servers
To use LDAP authentication, enable it and enter the information you have
gathered.
Note that you must enter information in the fields showing the message
'required.'
To add LDAP/LDAPS servers:
1.
Choose Device Settings > Security > Authentication.
2.
Click New in the LDAP Servers section.
3.
Enter information.
Field/setting
Description
IP Address /
Hostname
The IP address or hostname of your LDAP/LDAPS server.
Important: Without the encryption enabled, you can type either the
domain name or IP address in this field, but you must type the
fully qualified domain name if the encryption is enabled.
Copy settings from
existing LDAP server
This checkbox appears only when there are existing AA server
settings on the PX3. To duplicate any existing AA server's settings,
refer to the duplicating procedure below.
Summary of Contents for PX3-1000 series
