Chapter 6: Using the Web Interface
266
2.
Select the following checkbox. Then the PX3 always tries external
authentication first. Whenever the external authentication fails, the
PX3 switches to local authentication.
3.
Click Save.
To disable external authentication:
1.
In the Authentication Type, select Local.
2.
Click Save.
Configuring Login Settings
Choose Device Settings > Security > Login Settings to open the Login
Settings page, where you can:
Configure the user blocking feature.
Note: The user blocking function applies only to local authentication
instead of external authentication through AA servers.
Determine the timeout period for any inactive user.
Prevent simultaneous logins using the same login name.
To configure user blocking:
1.
To enable the user blocking feature, select the "Block user on login
failure" checkbox.
2.
In the "Maximum number of failed logins" field, type a number. This
is the maximum number of login failure the user is permitted before
the user is blocked from accessing the PX3.
3.
In the "Block timeout" field, type a value or click
to select a
time option. This setting determines how long the user is blocked.
If you type a value, the value must be followed by a time unit,
such as '4 min.' See
Time Units
(on page 153).
4.
Click Save.
Summary of Contents for PX3-1000 series
