Chapter 7: Using SNMP
359
6.
Click Save.
SNMPv3 Notifications
1.
Choose Device Settings > Network Services > SNMP.
2.
In the SNMP Agent, make sure the Enable SNMP v1/v2c checkbox is
selected.
3.
In the SNMP Notifications section, make sure the Enable SNMP
Notifications checkbox is selected.
4.
Select SNMPv3 Trap or SNMPv3 Inform as the notification type.
5.
For SNMP TRAPs, the engine ID is prepopulated.
6.
Type values in the following fields.
Field
Description
Host
The IP address of the device(s) you want to access.
This is the address to which notifications are sent
by the SNMP agent.
Port
The port number used to access the device(s).
User ID
User name for accessing the device.
Make sure the user has the SNMP v3 access
permission.
Timeout
The interval of time, in seconds, after which a new
inform communication is resent if the first is not
received.
For example, resend a new inform
communication once every 3 seconds.
Number of Retries Specify the number of times you want to resend the
inform communication if it fails.
For example, inform communications are
resent up to 5 times when the initial
communication fails.
Security Level
Three types are available.
noAuthNoPriv - neither authentication nor
privacy protocols are needed.
AuthNoPriv - only authentication is required.
authPriv - both authentication and privacy
protocols are required.
Summary of Contents for PX3-1000 series
