Chapter 8: Using the Command Line Interface
489
Type
Description
vibration The
connected
detector/switch is for detection of
the vibration.
Setting the X Coordinate
This command specifies the X coordinate of an environmental sensor.
config:#
externalsensor <n> xlabel "<coordinate>"
Variables:
<n> is the ID number of the environmental sensor that you want to
configure. The ID number is available in the PX3 web interface or
using the command "
show externalsensors <n>
" in the CLI. It is
an integer between 1 and 32.
<coordinate> is a string comprising up to 24 ASCII printable
characters, and it must be enclosed in quotes.
Setting the Y Coordinate
This command specifies the Y coordinate of an environmental sensor.
config:#
externalsensor <n> ylabel "<coordinate>"
Variables:
<n> is the ID number of the environmental sensor that you want to
configure. The ID number is available in the PX3 web interface or
using the command "
show externalsensors <n>
" in the CLI. It is
an integer between 1 and 32.
<coordinate> is a string comprising up to 24 ASCII printable
characters, and it must be enclosed in quotes.
Summary of Contents for PX3-1000 series
