Chapter 8: Using the Command Line Interface
523
Enabling or Disabling Load Shedding
This section applies to outlet-switching capable models only.
This command determines whether to enter or exit from the load
shedding mode.
#
loadshedding <option>
After performing the above command, PX3 prompts you to confirm the
operation. Press
y
to confirm or
n
to abort the operation.
To skip the confirmation step, you can add the "/y" parameter to the end
of the command so that the operation is executed immediately.
#
loadshedding <option> /y
Variables:
<option> is one of the options:
enable or disable.
Option
Description
start
Enter the load shedding mode.
stop
Quit the load shedding mode.
Example
The following command has the PX3 enter the load shedding mode.
config:#
loadshedding start
Summary of Contents for PX3-1000 series
