Appendix C: Configuration or Firmware Upgrade with a USB Drive
558
devices.csv
If there are device-specific settings to configure, you must create a
device list configuration file -
devices.csv, to store unique data of each
PX3.
This file must be:
An excel file in the CSV format.
Copied to the root directory of the USB drive.
Referenced in the
device_list option of the "fwupdate.cfg" file. See
fwupdate.cfg
(on page 551).
Every PX3 identifies its entry in the "devicelist.csv" file by comparing its
serial number or MAC address to one of the columns in the file.
Determine the column to identify PX3 devices:
By default, a PX3 searches for its serial number in the 1st column.
To override the default, set the
match option in the "fwupdate.cfg"
file to a different column.
Syntax:
Prior to release 3.1.0, only single-line values containing NO commas
are supported. A comma is considered a field delimiter.
For example:
Value-1,Value-2,Value-3
As of release 3.1.0, values containing commas, line breaks or double
quotes are all supported. The commas and line breaks to be
included in the values must be enclosed in double quotes. Every
double quote to be included in the value must be escaped with
another double quote.
For example:
Value-1,"Value-2,with,three,commas",Value-3
Value-1,"Value-2,""with""three""double-quotes",Valu
e-3
Value-1,"Value-2
with a line break", Value-3
Summary of Contents for PX3-1000 series
