Appendix C: Configuration or Firmware Upgrade with a USB Drive
561
Illustration:
In this example, we will encrypt the word "private", which is the value
of the SNMP write community in the "config.txt" file.
1.
In the CLI, type the following command to encrypt "private."
2.
The CLI generates and shows the encrypted form of "private."
3.
In the "config.txt" file, make the following changes to the SNMP write
community setting.
a.
Replace the word "private" with the encrypted value that CLI
shows.
b.
Add "encrypted:" to the beginning of that setting.
Firmware Upgrade via USB
Firmware files are available on Raritan website's
Support page
(
Note that if the firmware file used for firmware upgrade is the same as
the firmware version running on the PX3, no firmware upgrade will be
performed unless you have set the
force_update option to true in the
"fwupdate.cfg" file. See
fwupdate.cfg
To use a USB drive to upgrade the PX3:
1.
Copy the configuration file "fwupdate.cfg" and an appropriate
firmware file to the root directory of the USB drive.
2.
Reference the firmware file in the
image option of the "fwupdate.cfg"
file.
3.
Plug the USB drive into the USB-A port on the PX3.
Summary of Contents for PX3-1000 series
