Appendix G: Old PX3 Character LCD Display
615
Measurement
units
Sensor types
%
A relative humidity sensor
A temperature sensor
m/s
An air flow sensor
Pa
An air pressure sensor
NO measurement
units
For an "absolute" humidity sensor, the
measurement unit is g/m
3
, which cannot be
displayed on the LCD.
Available states for a state sensor:
States
Description
nor Normal
state.
ALA Alarmed
state.
This state is accompanied with the word "ALARM"
below it.
Available states for a dry contact signal actuator (DX sensor
series):
States
Description
On
The actuator is turned on.
Off
The actuator is turned off.
Note: Numeric sensors show both numeric readings and sensor
states to indicate environmental or internal conditions while state
sensors show sensor states only to indicate state changes.
5.
Press the FUNC button to show the sensor's port position. There are
two types of information.
P:n (where n is the SENSOR port's number): This information
indicates the SENSOR port number.
C:x (where x is the sensor's position in a sensor chain): This
information indicates the sensor's position in a chain, which is
available for DPX2, DPX3 and DX sensors only. The LCD display
will cycle between the port information (
P:n) and chain position
information (
C:x).
Summary of Contents for PX3-1000 series
