Chapter 6: Using the Web Interface
195
To retrieve the exact data at a particular time, hover your mouse
over the data line in the chart. Both the time and data are
displayed as illustrated below.
To configure this OCP's threshold settings:
By default, upper thresholds of an OCP's RMS current have been
configured. See
Default Voltage and Current Thresholds
(on page 801).
You can modify them as needed.
Note: The threshold values set for an individual OCP will override the
bulk threshold values stored on that particular OCP. To configure
thresholds for multiple OCPs at a time, see
OCPs
(on page 191).
1.
Click the Thresholds title bar at the bottom of the page to display the
threshold data.
2.
Click the RMS current sensor (required), and then click Edit
Thresholds.
3.
Make changes as needed.
To enable any threshold, select the corresponding checkbox.
Summary of Contents for PX3-3000 series
