Chapter 6: Using the Web Interface
205
For concepts of thresholds, deassertion hysteresis and assertion
timeout, see
Sensor Threshold Settings
(on page 793).
4.
Click Save.
Tip: To customize the threshold settings on a per-sensor basis, go to
Individual Sensor/Actuator Pages
(on page 214).
To turn on or off any actuator(s):
1.
Select one or multiple actuators which are
in the same status - on or
off.
To select multiple actuators, click
to make checkboxes
appear and then select desired actuators.
2.
Click the desired button.
: Turn ON.
: Turn OFF.
Note: If you try to turn on more than one "powered dry contact"
actuators, by default only one "powered dry contact" actuator can be
turned on at the same time. You can change this limitation by
changing the active powered dry contact setting. See
PDU
(on page
3.
Confirm the operation when prompted.
Tip: If intending to control the actuator via the front panel, see
Front
Panel Settings
(on page 375).
Summary of Contents for PX3-3000 series
