Chapter 8: Using the Command Line Interface
625
If you entered the command without "/y", a message appears, prompting
you to confirm the operation. Then:
Type
y
to confirm the operation, OR
Type
n
to abort the operation
Example - Turning On a Specific Actuator
The following command turns on the actuator whose ID number is 8.
#
control actuator 8 on
Unblocking a User
If any user is blocked from accessing the PX3, you can unblock them at
the local console.
To unblock a user:
1.
Log in to the CLI interface using any terminal program via a local
connection. See
With HyperTerminal
(on page 445).
2.
When the Username prompt appears, type
unblock
and press
Enter.
3.
When the "Username to unblock" prompt appears, type the name of
the blocked user and press Enter.
4.
A message appears, indicating that the specified user was unblocked
successfully.
Resetting the PX3
You can reset the PX3 device to factory defaults or simply restart it using
the CLI commands.
Summary of Contents for PX3-3000 series
