Chapter 6: Using the Web Interface
132
Changing Modbus/TCP Settings
You can enable or disable the Modbus/TCP access to the PX or the
read-only mode, or change the default TCP port for the Modbus service.
To change the Modbus service settings:
1. Choose Device Settings > Network Services > Modbus. The Modbus
Settings dialog appears.
2. To enable the Modbus access, select the Enable Modbus/TCP
Access checkbox. To disable it, deselect the checkbox.
3. To use a different port, type a new port number in the port field. Valid
range is 1 to 65535.
4. To enable the Modbus read-only mode, select the "Enable read-only
mode" checkbox. To disable it, deselect the checkbox.
Summary of Contents for PX3-4000 series
