Chapter 6: Using the Web Interface
235
6. In the "Syslog server" field, specify the IP address to which the
syslog is forwarded.
7. In the Transport Protocol field, select one of the syslog protocols:
TCP or UDP. The default is UDP.
Transport
protocol types
Next steps
UDP
In the UDP Port field, specify an appropriate port number. Default is 514.
Select the "Legacy BSD Syslog Protocol (UDP only)" checkbox if applicable.
If NO TLS certificate is required, type an appropriate port number in the TCP Port field.
TCP
If a TLS certificate is required, select the "Enable Secure Syslog over TLS" checkbox, and
then do the following:
a. Specify an appropriate port number in the "TCP Port (TLS)" field. Default is 6514.
b. In the CA Certificate field, click Browse to select a TLS certificate. After installing the
certificate, you may:
Click Show to view its contents.
Click Remove to delete it if it is inappropriate.
c. Determine whether to select the "Allow expired and not yet valid certificates"
checkbox.
To always send the event message to the specified syslog server after a TLS
certificate has been installed, select this checkbox.
To prevent the event message from being sent to the specified syslog server
when any TLS certificate in the selected certificate chain is outdated or not valid
yet, deselect this checkbox.
8. Click OK.
Summary of Contents for PX3-4000 series
