Chapter 6: Using the Web Interface
240
5. In the Action field, click the drop-down arrow and select the desired
action: Switch LHX/SHX.
6. From the Operation drop-down, select Turn LHX/SHX On or Turn
LHX/SHX Off.
7. From the Available LHX/SHXs list box, click on the LHX/SHX to be
turned on or off, then click
or
to add to the Switched
LHX/SHXs list box. Use
or
to remove the LHX/SHX from the
Switched LHXs list box, thereby removing the action.
8. Click OK.
Switch Outlets
The "Switch outlets" action is available only when your PX is
outlet-switching capable. This action turns on, off or power cycles a
specific outlet.
To switch on, off or power cycle any outlet(s):
1. Click the Actions tab.
2. Click New.
3. In the "Action name" field, type a new name for the action. The
default name is New Action <number>, where <number> is a
sequential number starting at 1.
4. In the Action field, click the drop-down arrow and select the desired
action: Switch outlets.
5. From the Operation drop-down list, select an operation for the
selected outlet(s).
Turn Outlet On: Turns on the selected outlet(s).
Turn Outlet Off: Turns off the selected outlet(s).
Cycle Outlet: Cycles power to the selected outlet(s).
6. To select the outlet where this action will be applied, select it from
the Available Outlets list box and click
to move it to the Switched
Outlets list box. To make multiple selections, press Ctrl+click or
Shift+click to highlight multiple ones.
To move all outlets to the Switched Outlets list box, click
.
7. To remove any outlet from the Switched Outlets list, select it from the
Switched Outlets list box and click
to move it to the Available
Outlets list box. To make multiple selections, press Ctrl+click or
Shift+click to highlight multiple ones.
To remove all outlets, click
.
8. Click OK to save the new action.
9. Click Close to quit the dialog.
Summary of Contents for PX3-4000 series
