Chapter 3: Installation and Configuration
14
Connecting a Locking Line Cord
If your PDU is a PX3
Phase II
model, it is shipped with either of the
following locking line cords.
A line cord with locking clips: A locking inlet on the PDU is required
for this cord.
A line cord with slide release buttons: This line cord automatically
locks after being connected to the inlet. A locking inlet is not required
for this cord.
A locking inlet and/or locking line cord ensure that the line cord is
securely fastened to the inlet.
To connect a cord with locking clips:
Make sure the line cord's locking clips fit into the locking holes at two
sides of the inlet when plugging the cord's connector into the PDU's
locking inlet.
Number Item
1
Locking holes on the inlet
2
Locking clips of the line cord
Summary of Contents for PX3-4000 series
