Chapter 7: Using SNMP
336
Security level
Description
"noAuthNoPriv"
Select this if no authorization or privacy protocols
are needed.
"authNoPriv"
Select this if authorization is required but no
privacy protocols are required.
Select the authentication protocol - MD5 or
SHA
Enter the authentication passphrase and then
confirm the authentication passphrase
"authPriv"
Select this if authentication and privacy protocols
are required.
Select the authentication protocol - MD5 or
SHA
Enter the authentication passphrase and
confirm the authentication passphrase
Select the Privacy Protocol - DES or AES
Enter the privacy passphrase and then confirm
the privacy passphrase
SNMP Gets and Sets
In addition to sending traps, the PX is able to receive SNMP get and set
requests from third-party SNMP managers.
Get requests are used to retrieve information about the PX, such as
the system location, and the current on a specific outlet.
Set requests are used to configure a subset of the information, such
as the SNMP system name.
Note: The SNMP system name is the PX device name. When you
change the SNMP system name, the device name shown in the web
interface is also changed.
The PX does NOT support configuring IPv6-related parameters using
the SNMP set requests.
Valid objects for these requests are limited to those found in the SNMP
MIB-II System Group and the custom PX MIB.
Summary of Contents for PX3-4000 series
