Chapter 8: Using the Command Line Interface
346
Help Command
The help (?) command shows a list of main CLI commands available for
the current mode. This is helpful when you are not familiar with CLI
commands.
Help command under the administrator mode:
#
?
Help command under the configuration mode:
config:#
?
Help command under the diagnostic mode:
diag:#
?
Press Enter after typing the help command, and a list of main commands
for the current mode is displayed.
Tip: You can check what parameters are available for a specific CLI
command by adding the help command to the end of the queried
command. See
Querying Available Parameters for a Command
(on
page 347).
Summary of Contents for PX3-4000 series
