Chapter 8: Using the Command Line Interface
349
Networking Mode
This command shows whether the current networking mode is wired or
wireless.
#
show network mode
Note: If the PX is a slave device connected to the LAN via the master PX
device, the
show network mode
command displays
wired(USB)
instead
of
wired
.
Wireless Configuration
This command only shows the wireless configuration of the PX device,
such as the SSID parameter.
#
show network wireless
To show detailed information, add the parameter "details" to the end of
the command.
#
show network wireless
details
Network Service Settings
This command shows the network service settings only, including the
Telnet setting, TCP ports for HTTP, HTTPS, SSH and Modbus/TCP
services, and SNMP settings.
#
show network services <option>
Variables:
<option> is one of the options:
all
,
http
,
https
,
telnet
,
ssh
,
snmp
,
modbus
and
zeroconfig
.
Option
Description
all
Displays the settings of all network services,
including HTTP, HTTPS, Telnet, SSH and SNMP.
Tip: You can also type the command without
adding this option "all" to get the same data.
http
Only displays the TCP port for the HTTP service.
Summary of Contents for PX3-4000 series
