Chapter 8: Using the Command Line Interface
352
Inlet Information
This command syntax shows the inlet information.
#
show inlets <n>
To show detailed information, add the parameter "details" to the end of
the command.
#
show inlets <n>
details
Variables:
<n> is one of the options:
all
, or a number.
Option
Description
all
Displays the information for all inlets.
Tip: You can also type the command without
adding this option "all" to get the same data.
A specific inlet
number
Displays the information for the specified inlet only.
An inlet number needs to be specified only when
there are more than 1 inlet on your PDU.
Displayed information:
Without the parameter "details," only the inlet's name and RMS
current are displayed.
With the parameter "details," more inlet information is displayed in
addition to the inlet name and RMS current, such as the inlet's RMS
voltage, active power and active energy.
Summary of Contents for PX3-4000 series
