Chapter 8: Using the Command Line Interface
374
Server Reachability Information for a Specific Server
To show the server reachability information for a certain IT device only,
use the following command.
#
show serverReachability
server <n>
To show detailed information, add the parameter "details" to the end of
the command.
#
show serverReachability
server <n> details
Variables:
<n> is a number representing the sequence of the IT device in the
monitored server list.
You can find each IT device's sequence number using the CLI
command of
show serverReachability
as illustrated below.
Displayed information:
Without the parameter "details," only the specified device's IP
address, monitoring enabled/disabled state and current status are
displayed.
With the parameter "details," more settings for the specified device
are displayed, such as number of pings and wait time prior to the
next ping.
Summary of Contents for PX3-4000 series
