Chapter 8: Using the Command Line Interface
397
Setting the IPv4 Subnet Mask
After selecting the static IP configuration mode, you can use this
command to define the subnet mask.
config:#
network ipv4 subnetMask <netmask>
Variables:
<netmask> is the subnet mask address. The value ranges from
0.0.0.0 to 255.255.255.255.
Setting the IPv4 Gateway
After selecting the static IP configuration mode, you can use this
command to specify the gateway.
config:#
network ipv4 gateway <ip address>
Variables:
<ip address> is the IP address of the gateway. The value ranges
from 0.0.0.0 to 255.255.255.255.
Setting the IPv4 Primary DNS Server
After selecting the static IP configuration mode, use this command to
specify the primary DNS server. If you have selected the DHCP
configuration mode, you still can manually specify DNS servers with this
command and then override the DHCP-assigned DNS servers. See
Overriding the IPv4 DHCP-Assigned DNS Server
(on page 398).
config:#
network ipv4 primaryDNSServer <ip address>
Variables:
<ip address> is the IP address of the primary DNS server. The value
ranges from 0.0.0.0 to 255.255.255.255.
Summary of Contents for PX3-4000 series
