Chapter 8: Using the Command Line Interface
400
Setting the IPv6 Configuration Mode
This command determines the IP configuration mode.
config:#
network ipv6 ipConfigurationMode <mode>
Variables:
<mode> is one of the modes:
automatic
or
static
.
Mode
Description
automatic
The IPv6 configuration mode is set to automatic.
static
The IPv6 configuration mode is set to static IP
address.
Setting the IPv6 Preferred Host Name
After selecting DHCP as the IPv6 configuration mode, you can specify
the preferred host name, which is optional. The following is the
command:
config:#
network ipv6 preferredHostName <name>
Variables:
<name> is a host name which:
Consists of alphanumeric characters and/or hyphens
Cannot begin or end with a hyphen
Cannot contain more than 63 characters
Cannot contain punctuation marks, spaces, and other symbols
Summary of Contents for PX3-4000 series
